Velocity Edge GX325 Manual de usuario descargar pdf (Pagina 36)

Installing Clip-On Gaskets

There is one kind of channel arrangement. The ﬁ rst, uneven and

last channel will always be S2/S4. The even channels will always

be S1/S3. The Tranter standard connection location is hot in/out

S1/S3. Therefore, it will start and end with a cold channel. If a

hot in/out in S2/S4 is required, the ﬁ rst and last channels will

subsequently be hot.

1. Attach half-A gasket to the start plate in the RORU

orientation, as in Figure 46. Hang by the ORU orientation,

as shown in Figure 45.

2. Attach B gaskets to even plates by the LOLU orientation. (See

Figure 46.) Hang by the ORD orientation, so the “O” is in

the lower right corner. (See Figure 45.) This is equivalent to

Channel B.

3. Attach A gaskets to odd plates by the RORU orientation,

as shown in Figure 46. Hang by the ORU orientation, as in

Figure 45. This forms a Channel A.

4. Attach B gasket to end plate by the LOLU orientation, and

attach half-A gasket to the backside of the end plate by the

RORU orientation. (See Figure 46.) Hang by the ORD

orientation with B gasket facing inside. (See Figure 45.) This

completes the plate pack.

The following is an example of the above in a GLD-013 heat

exchanger:

PLATE SEQUENCE ATTACHING HANGING

1 RORU Start ORU

2, 4..54, 56 LOLU ORD

3, 5..55, 57 RORU ORU

58, 60..70, 72 LOLU ORD

59, 61..71, 73 RORU ORU

74 LOLU End ORD

QUANTITY ATTACHING

1 RORU Start

28 LOLU

36 RORU

8 LOLU

1 LOLU End

Plate Hanging Assembly

Gasket Attaching Assembly

ORU ORD

Figure 45

Plate hanging orientation.

Start plate

RORU

Figure 46

Gasket attaching orientation.

Even plates

LOLU

Odd plates

RORU

End plate

LOLU

End plate

RORU

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comentarios a estos manuales

Sin comentarios

Velocity Edge GX325 Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo Velocity Edge GX325