Velocity Edge GX325 Manual de usuario descargar pdf (Pagina 25)

PLATE NO. GASKET PLATE GLUING HANGING

1 NBR (S) H0230 RC START B

2, 4, 6, 8, 10 NBR (S) H1234 LG E

3, 5, 7, 9, 11 NBR (S) H1234 RC B

12, 14, 16, 18 NBR (S) H1234 LG G, E

13, 15, 17, 19 NBR (S) H1234 RC C, B

20 NBR (S) H1234 LG G

21 NBR (S) H1004 RC END C

22 — H1004 PARTITION

23 NBR (S) H1004 RC START B

24, 26, 28, 30, 32 NBR (S) H1234 LG E

25, 27, 29, 31, 33 NBR (S) H1234 RC B

34, 36, 38, 40 NBR (S) H1234 LG G, E

35, 37, 39, 41 NBR (S) H1234 RC C, B

42 NBR (S) H1234 LG G

43 NBR (S) H0230 RC END C

Model: GXD-060; Plate Material: 304 SS; Plate Thickness: 0.5 mm.

Table 9

Typical Hanging Speciﬁcation

Plate No.: Indicates plate number if single number is given.

Indicates a numerical sequence pattern if multiple numbers

are given. If multiple letter codes are given in the Hanging

column, an alternating sequence between the two letters should

be followed as indicated in the Plate No. column.

Gasket: Deﬁnes the gasket material.

Plate: A ﬁve-digit identiﬁer, which describes plate theta as being

“H” high or “L” low, is followed by four integers. These four

integers indicate which ports are pierced. A zero (0) denotes NO

piercing at this port location.

Gluing: An eight-character ﬁeld describing how the gasket is

to be glued to the plate. The ﬁrst letter describes whether the

closed port (ringed gasket corner) is in the Lower Right or Lower

Left. Therefore, “R” is Right and “L” is Left. The second letter

denotes the plate letter code. Both of these descriptions apply

when the plate is viewed upright with the designated letter code

being read left-to-right in the upper right hand quadrant of the

plate. Gaskets will be glued to the front of plate as viewed in their

installed orientation from front-to-back of the assembled unit.

“Start” or “End” can be added to the ﬁrst two-letters with a space

between to denote special gasketing instructions for the ﬁrst and

last plates between end-frames and/or partition plates.

Hanging: Indicates the letter code by which a plate is to be hung

in the unit. This letter should be located in the upper right of

the plate and read from left-to-right. The plate should be viewed

as if from looking from the front of the unit.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentarios a estos manuales

Sin comentarios

Velocity Edge GX325 Manual de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo Velocity Edge GX325