Velocity Edge GX325 Manual de usuario descargar pdf (Pagina 18)

PLATE STYLES

Unlike all other SUPERCHANGER models, the GX series of

plates is based on a diagonal ﬂ ow pattern. On a typical one-by-

one pass unit, nozzle numbers 1 and 3 will be the hot inlet and

hot outlet connections. Nozzle numbers 2 and 4 are the cold inlet

and cold outlet located lower right and upper left, respectively.

Unlike other plates, GX series can also be designed for parallel

ﬂ ow. The ﬂ ow direction is always designated in the model number

by a “P” (parallel) or “D” (diagonal) after the letters “GX.”

Figure 25

ULTRAFLEX (GX) plate design.

Figure 27

GX type “L” plate.

Figure 26

GX type “H” plate.

Figure 28

GF-type plate.

ULTRAFLEX (GX) and WIDE-GAP (GF) plates differ from

conventional plates in another aspect. Because the gasket groove

lies in the plate’s neutral plane, additional conﬁ gurations are

possible with a given plate. This feature allows the heat exchanger

to be more precisely designed for each application.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sin comentarios

Velocity Edge GX325 Manual de usuario Pagina 18