Velocity Edge MX230 Manual de usuario descargar pdf (Pagina 44)

STEP 3

Place the controller mounting bracket on the cab floor

behind the operator’s seat with the studs (1) facing

forward and slotted tabs (2) on the floor. Install the

M8 bolt and washer provided in the notch at the

middle of the bracket and into the access panel.

STEP 4

Use the bracket as a template and mark the two

holes in the center of each slot (1). Remove the plate

and drill two 5/16 inch holes through the cab floor at

each marked location.

NOTE: Make sure there are no obstructions under

the cab before drilling.

Install two 1/4-20 bolts, washers and lock nuts

through the mounting bracket in the drilled holes.

Replace the M8 bolt and washer in the notch of the

mounting bracket and access panel. Tighten bolts.

NOTE: It may be easier to hold bolts in the cab

through the rear window while tightening the nuts

from outside the cab.

STEP 5

Center the controller mounting plate on the front of

the mounting bracket. The end of the plate with the

most threaded holes (1) should be on the right side

and the countersink holes (2) should be facing

forward. Install four 1/4 - 20 bolts (3), washers and

nuts in the mounting plate and bracket. Tighten bolts.

RD04K159

RD04K160

1 2 ... 39 40 41 42 43 44 45 46

Sin comentarios

Velocity Edge MX230 Manual de usuario Pagina 44