Velocity Edge MX230 Manual de usuario descargar pdf (Pagina 36)

POWER HARNESS INSTALLATION

RD04K156

NOTE: Route all harnesses, wires, and cables along routes that are free of obstructions and pinch points. Use

wire ties where necessary. Connectors on all harnesses are identified by component for ease of installation. The

following instructions will only give the installer the general direction to route the components. The installer will be

responsible for determining the best method to conceal all routings.

NOTE: Make note of where any wire harness and hose tie straps were removed during disassembly so they can

be properly installed during assembly.

STEP 1

Remove the right hand fender control panel by

pulling up on the edge closest to the seat. Set the

control panel off to the side.

1. ACCESSORY JUMPER CABLE 10. PIN A +JBK

2. FUSE HOLDER 11. PIN A -JBK

3. EXTRA ACCESSORY OUTLET 12. POWER HARNESS POWER/GROUND CONNECTOR

4. ACCESSORY JUMPER CABLE GROUND 13. POWER HARNESS

5. CONNECTOR CAVITY PLUGS 14. GROUND WIRE TO SWITCH

6. -JBK 15. POWER WIRE TO SWITCH

7. -PPB 16. SWITCHED POWER WIRE

8. +PPB 17. SWITCH

9. +JBK 18. ACCESSORY JUMPER CABLE POWER

RD04B017

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Sin comentarios

Velocity Edge MX230 Manual de usuario Pagina 36