Velocity Edge MX230 Manual de usuario descargar pdf (Pagina 35)

AgGPS170 Display System Cable Layout

RD04F277

Ag170 DISPLAY SYSTEM

STEP 1

Connect the Ag170 Display harness to the display,

lightbar (if equipped) and button box (if equipped).

Route the leads with the power connections,

Sonalert alarm harness connector, computer

connector and switch/alarm connector toward the

right rear corner of the cab.

STEP 2

Route the power and ground leads into the

electronics bay. Leave leads in electronics bay.

STEP 3

Determine a position to install the Sonalert alarm.

This position should be within audible range of the

operator so the alarm can be heard when activated.

You can have the alarm lay loose or drill a hole in an

unobstructed trim panel and mount the alarm.

Connect the Sonalert alarm harness to the alarm.

Route the controller connector toward the front of the

seat at the floor. Controller connections will be made

later.

1. Ag170 DISPLAY 9. AgGPS 170 POWER CONNECTION

2. DISPLAY HARNESS 10. SWITCH/ALARM CONNECTOR (NOT USED THIS

APPLICATION)

3. LIGHTBAR DISPLAY (OPTIONAL) 11. LIGHTBAR HARNESS (OPTIONAL)

4. CONTROLLER 12. RDL CONNECTOR (USED ONLY FOR

CONTROLLER SERVICING)

5. BUTTON BOX (OPTIONAL) 13. COMPUTER CONNECTION

6. SONALERT ALARM HARNESS 14. LIGHTBAR CONNECTION (NOT USED THIS

APPLICATION)

7. SONALERT ALARM 15. BUTTON BOX CONNECTION (NOT USED THIS

APPLICATION)

8. DISPLAY CONNECTION

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Sin comentarios

Velocity Edge MX230 Manual de usuario Pagina 35