Velocity Edge MX230 Manual de usuario descargar pdf (Pagina 21)

STEP 5

Apply a small amount of LOCTITE® Threadlocker

242 (supplied in kit) to each 10-24 screw and secure

the rotary potentiometer to the angle sensor.

STEP 6

NOTE: Failure to perform this step could result in

damage to the steering sensor.

The angle sensor shaft will only turn 180 degrees. Do

not force the shaft to turn. Find the midpoint of the

shaft’s travel (90 degrees) and permanently mark the

shaft and angle sensor body. These marks will be

used later during the installation procedure.

If a multimeter is available, center sensor using this

step. Place a multimeter on the right pin (1) and

center pin (2) of the steering sensor as shown.

Record the current resistance. Turn the knurled end

of the sensor all the way in the direction it will allow

you to turn. Record this resistance. Average the two

resistances to determine the midpoint of the sensor.

Turn the sensor until the midpoint resistance is

displayed on the multimeter, then mark the position

of the sensor.

NOTE: The angle sensor assembly shaft is spring

loaded and will slowly turn back to the zero degree

position.

RD04H654

RD04H656

RD04K031

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Sin comentarios

Velocity Edge MX230 Manual de usuario Pagina 21