Velocity Edge GX440 Guía de usuario Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 412
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
Device Configuration
Rev 1 Oct.13 25
Client Configuration
Creating Client Tunnel
Configure the SSH client to create a tunnel when it connects to the AirLink device.
(In this example, PuTTY is used to create the tunnel.)
1. Create a new SSH session by entering the IP address of the AirLink device,
and the configured port. (In this example, the IP Address of the AirLink device
is 74.198.207.51 and default port 22 is used.)
Figure 2-10: PuTTY: Creating a new SSH session
2. Click Save.
3. Go to Connection > SSH > Tunnels.
4. Create an SSH tunnel for the connection by creating a forwarded port.
In the Source port field, enter the same value as the Device Port field config-
ured in ACEmanager Serial port configuration (12345 in this example). This is
the port that the PAD session listens on for incoming connections.
In the Destination address field, enter the IP address of the AirLink device.
(You can find this in ACEmanager on the Status > Home page.) The port is
also listening to the TCP port for PAD mode (Device Port on the Serial tab)
which, in this example, is 12345.
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 411 412

Comentarios a estos manuales

Sin comentarios